NABCEP PV Installation Professional (PVIP) Board Certification : PVIP

여러분은 열악한 취업환경속에서 치열한 경쟁을 많이 느낄것입니다. 치열한 경쟁속에서 자신의 위치를 보장하는 길은 더 많이 배우고 더 많이 노력하는것 뿐입니다.

NABCEP PVIP 시험은 국제인증자격증중에서 뜨거운 인기를 누리고 있습니다. Pass4Test는 국제인증자격증 시험에 대비한 PV Installation Professional (PVIP) Board Certification시험전 공부자료를 제공해드리는 전문적인 사이트입니다.한방에 쉽게 PV Installation Professional (PVIP) Board Certification시험에서 고득점으로 패스하고 싶다면 PV Installation Professional (PVIP) Board Certification시험자료를 선택하세요.저렴한 가격에 비해 너무나도 높은 시험적중율과 시험패스율을 자랑하는 NABCEP PVIP덤프를 제작하기 위해 최선을 다하고 있습니다.

Pass4Test에서 제공해드리는 덤프와의 근사한 만남이 PV Installation Professional (PVIP) Board Certification 최신 시험패스에 화이팅을 불러드립니다. 덤프에 있는 문제만 공부하면 되기에 시험일이 며칠뒤라도 시험패스는 문제없습니다. 더는 공부하지 않은 자신을 원망하지 마시고 결단성있게 PV Installation Professional (PVIP) Board Certification최신덤프로 시험패스에 고고싱하세요.

덤프는 구체적인 업데이트 주기가 존재하지 않습니다. 하지만 저희는 수시로 NABCEP PVIP시험문제 변경을 체크하여 PV Installation Professional (PVIP) Board Certification덤프를 가장 최신버전으로 업데이트하도록 최선을 다하고 있습니다. 덤프가 업데이트되면 업데이트된 최신버전을 고객님 구매시 사용한 메일주소로 발송해드립니다. NABCEP PVIP자료를 구매하신후 60일내로 불합격받고 환불신청하시면 덤프결제를 취소해드립니다.

구매후 PVIP덤프를 바로 다운: 결제하시면 시스템 자동으로 구매한 제품을 고객님 메일주소에 발송해드립니다.(만약 12시간이내에 덤프를 받지 못하셨다면 연락주세요.주의사항:스펨메일함도 꼭 확인해보세요.)

최신 NABCEP Board PVIP 무료샘플문제:

1. A 7KW/ 14 KWh multimode system has been installed at a residence, ac-couple with the customer's existing
6.7kwh ac PV system. The system providers uninterrupted power to a protect loads subpanel, which is connected to a refrigerator, Microwave, 1.0 ton are conditioner, three lightning circuit, and the 6.7kwac PV system. One month later, the homeowner moves additional circuits to the protected loads subpanel, substantially increasing the loads. Why would this cause, the backfed interconnection breaker in the main service panel to trip?

A) The toad exceeds the capacity of the interconnection breaker.
B) The load «the protected loads subpanel exceeds the PV system ac rating by 25%.
C) The total load exceeds the system's energy storage capacity of 14kWh.
D) The main service panel is no longer compliant with NCC 705.12.

2. An installer is using ½ in lag boits to secure roof-monitoring hardware to rafters through a roof deck. Which of the following should the installer predrill?

A) A 5/16 in pilot hole through the roof into the rafter
B) A pilot hole one-fourth the length of the bolt
C) A pilot hole one-half the length of the bolt
D) A 1/8 in, pilot hole through the roof into the rafter

3. A 10 kW system has a total derate factor of 0.85 and operates at 5 PSH. What is the daily output in summer with 10% soiling loss?

A) 47.5 kWh
B) 42.5 kWh
C) 38.25 kWh
D) 36.0 kWh

4. An 8KWsc roof-mounted array is placed on a school building. The inverter is located within 1 ft, of the array boundary and has an integrated ac-and dc-disconnecting switch. The system is to be connected to a 400A load center, protected by a 400A main breaker. Which of the following MUST be included to meet NEC requirements?

A) An ac-disconnect label with the location of the rooftop dc-disconnect switch.
B) A rapid shutdown initiation device operating contractor within 1 ft, of the array to de-energize the dc subarrays
C) A readily accessible ac-disconnecting switch, who location is identified on the system directory
D) A readily accessible dc disconnect with rapid shutdown initiation device permanently labeled

5. A PV system installation utilizes micro inverters connected to each module of the array. Each micro inverter has a nominal rated output of 250WV. Single phase. The microinverters are listed so that multiple inverters may be connected in parallel to a single feeder circuit, and each inverter has an cable and connector rated for
30A. What is the MAXIMUM number of inverters that may be wired together on a single 30A feeder circuit?

A) 28
B) 17
C) 15
D) 23

질문과 대답: